Browse Jaguar parts currently in stock. Fitment notes and OEM numbers are added as we curate each listing.
Anti roll bar mounting washer for both front and rear applications. It is used to secure the anti roll bar to its mounting points on Series vehicles, Land Rover Defender (2007-2016), Discovery 1 and Range Rover Classic. This part supersedes part number 264024 and should be checked for wear or corrosion during suspension servicing.
€6.36
NewLast oneincl. VAT
Fir-tree retainer clip for the door card. It secures the inner door panels on Defender side and rear end doors by locating into the door card trim. This clip is fitted on applicable Defender models from VIN 6A719522 through to 2016.
€7.42
NewLast oneincl. VAT
A wiper rack intermediate tube. It fits the intermediate section of the windscreen wiper rack cable on Defender models built 2007-2016 from VIN 7A000001, forming the tubular section through which the rack cable runs to keep the assembly correctly located.
€8.48
NewLast oneincl. VAT
An O-Ring 21 x 3mm. Fitted to the air conditioning pipe connections at the condenser and compressor, it forms a pressure-tight seal in the air conditioning system.
€6.36
NewLast oneincl. VAT
An O ring for power assisted steering pipes. Fitted at the pipe joints on Defender power steering systems, this O ring seals the pipe connections to help prevent fluid loss and maintain system integrity during operation.
€10.60
NewLast oneincl. VAT
A 0.030 inch swivel pin housing shim. Fitted into the swivel pin housing of front axle swivel pin assemblies, this shim establishes a 0.030 inch clearance between the swivel pin and its housing to ensure correct running clearance and to reduce premature wear.
€9.54
NewLast oneincl. VAT
An output shaft snap ring for the MT82 manual transmission. It secures and retains the output shaft components inside the MT82 gearbox to prevent axial movement.
€5.30
NewLast oneincl. VAT
A 3/8 inch UNF propeller shaft bolt. Fitted to both front and rear propeller shafts, this bolt secures the shaft flanges together to retain the propshaft. Commonly referred to as a propshaft bolt, it uses a 3/8" UNF thread and is fitted to a range of Land Rover models
€10.07
NewLast oneincl. VAT
The M14 flanged nylon-insert lock nut used to secure the track rod end (tie rod end) ball joint on Freelander 2 steering assemblies.
€9.54
NewLast oneincl. VAT
M6 x 16mm flanged head set screw. It is supplied for general-purpose use across multiple Land Rover models where a metric flange-head screw is specified to secure assemblies.
€6.36
NewLast oneincl. VAT
Pan-head Torx screw, M10 x 20mm. Fitted to the front suspension on Range Rover L322 models, this screw secures the front ball joint arm to the suspension arm/X-member and provides the clamping required to retain the joint in service.
€8.48
NewLast oneincl. VAT
5.3 x 7mm semi-tubular flat rivet specified for use on the bodyshell. Fitted where Land Rover specifies this rivet, it is used to secure body panels and related trim on applicable models.
€8.48
NewLast oneincl. VAT
K3dparts Pro Locator
