60 Transmission & Drivetrain parts for Jaguar from our Hungary workshop — OEM and checked used components. Ships within the EU with no customs.
Land Rover Part Number: 255467 - Flanged-Head Bolt - Swivel Pin Housing 255467 is a flanged-head bolt for the swivel pin housing. Fitted to the swivel pin housing, this bolt provides the securing fastener that holds the swivel pin housing in place.
€9.54
NewLast oneincl. VAT
Hex-Headed Bolt M10 x 60mm - Defender, Discovery 1, Range Rover Classic
€6.36
NewLast oneincl. VAT
Pan-headed Torx screw with an M6 x 25mm specification. Fitted where small components require a secure fixing, this pan-headed Torx fastener secures various trim and minor components on applicable Land Rover models.
€6.36
NewLast oneincl. VAT
Flange-head bolt. Fitted to the front knuckle and hub assembly, this bolt fastens components and the integral flange head helps to distribute the clamping load, reducing localised stress on the joint
€6.36
New3 in stockincl. VAT
€7.42
NewLast oneincl. VAT
Hex-headed bolt used to fasten components on front axle cases, transmission mountings and rear cross members across multiple Land Rover models. It provides the clamping required to secure these structural and drivetrain assemblies; when fitting, ensure mating faces and threads are clean and the correct fastener specification and torque from the vehicle repair manual are used. Inspect the bolt for corrosion, thread damage or distortion and replace if any defects are found.
€8.48
NewLast oneincl. VAT
An output shaft snap ring for the MT82 manual transmission. It secures and retains the output shaft components inside the MT82 gearbox to prevent axial movement.
€5.30
NewLast oneincl. VAT
A 3/8 inch UNF propeller shaft bolt. Fitted to both front and rear propeller shafts, this bolt secures the shaft flanges together to retain the propshaft. Commonly referred to as a propshaft bolt, it uses a 3/8" UNF thread and is fitted to a range of Land Rover models
€10.07
NewLast oneincl. VAT
M6 x 16mm flanged head set screw. It is supplied for general-purpose use across multiple Land Rover models where a metric flange-head screw is specified to secure assemblies.
€6.36
NewLast oneincl. VAT
Selector Mechanism External (1.8 K16 Petrol,2.0L I4 8V TCIE,Manual Transmission)
€6.36
NewLast oneincl. VAT
M10 double hex-head bolt used on the swivel housing. It secures the oil seal retainer to the swivel housing and should be inspected for corrosion, thread damage or distortion whenever the swivel housing or drive shafts are serviced.
€1.00
New24 in stockincl. VAT
Front Differential Drive Unit (All Wheel Drive)
€5.30
NewLast oneincl. VAT
K3dparts Pro Locator
