Land Rover is well represented in our warehouse. Check compatibility on each product page before ordering.
LR073725 is an M8 flanged hex nut fitted to turbocharger and accessory drive fasteners on 2.0 L Ingenium diesel engines. It is used to retain those fasteners and should be replaced with the correct part when refitting the turbocharger or related accessory components.
€2.30
New5 in stockincl. VAT
NLP100290L is a spark plug used in the ignition system. Fitted to Freelander 1 models with 1.8 K Series engines and to automatic 2.5 KV6 engines, this plug provides the ignition source for the engine's combustion process.
€15.99
New4 in stockincl. VAT
LR022300 is a glow plug for the 2.2L diesel engine. Fitted into the combustion chamber, it provides heat during cold-start conditions to aid ignition and improve starting reliability on 2.2L diesel engines.
€39.78
New4 in stockincl. VAT
MOULDING - INSTRUMENT PANEL
€29.78
NewLast oneincl. VAT
Jaguar Pad wear sensor
€25.49
NewLast oneincl. VAT
Jaguar Glass - Door Mirror.
€40.25
NewLast oneincl. VAT
FTC3648 is a stub axle gasket. Fitted between the stub axle and the swivel pin housing or hub assembly, this gasket seals the joint on applicable Land Rover front and rear hubs.
€4.55
New9 in stockincl. VAT
LR122455 is a brake pad wear warning wire fitted to the front brake caliper assembly. It links the pad wear sensor contacts inside the caliper to the vehicle wiring loom, carrying the wear signal to the vehicle electronics so the driver is alerted when the pads reach their wear limit.
€39.49
New2 in stockincl. VAT
FS108206 is an M8 x 20mm flange-head screw, also referred to as a flange bolt. Fitted where a flange-head fastener is specified, this screw secures components on the Land Rover models listed below.
€1.98
New17 in stockincl. VAT
Jaguar starter motor, Anti Roll Bar-Front bolt, Clutch Housing, bolt
€3.15
New10 in stockincl. VAT
UYP500110 is an M10 grub screw used on gear shafts and selector yokes. It secures selector components on LT230 high/low gear shafts and within the selector yoke area of R380 gearboxes, preventing axial movement of selector parts. Fitment is shown in the compatibility list below; inspect the screw and mating threads during gearbox assembly or service and replace if worn or damaged.
€4.72
New9 in stockincl. VAT
LR003341 is a thermostat insert. Fitted into the thermostat housing on 3.6 TDV8 engines, the insert regulates coolant flow based on engine temperature to help maintain correct operating temperature. It is used on the Range Rover and Range Rover Sport models listed below.
€24.64
NewLast oneincl. VAT
K3dparts Pro Locator
