Land Rover is well represented in our warehouse. Check compatibility on each product page before ordering.
LR013275 is a glow plug fitted into each cylinder's combustion chamber on 3.0 V6 diesel and 4.4 diesel V8 engines to heat the intake air and assist engine starting.
€39.90
New2 in stockincl. VAT
Jaguar Spark plug boss seal
€3.99
New8 in stockincl. VAT
C2P17004 - Jaguar Pad wear sensor
€30.34
New2 in stockincl. VAT
LR023816 is a roof rack slat cover. It fits over the roof rack slat to conceal the mounting and to finish the roof rail installation.
€39.90
NewLast oneincl. VAT
LHV100150 is a timing belt idler pulley. Fitted to the timing belt on 300Tdi 2.5L I4 turbo engines, this pulley guides the belt routing and maintains correct belt alignment within the engine timing system.
€44.65
NewLast oneincl. VAT
Jaguar Pad wear sensor
€26.62
NewLast oneincl. VAT
Jaguar Pad wear sensor.
€29.94
New4 in stockincl. VAT
QRH100030 is a shear lock bolt for the steering column. It secures the steering lock to the steering column, and the bolt head is designed to shear off when correctly tightened so the head cannot be easily removed.
€7.35
New7 in stockincl. VAT
TDL500030 is a snap ring (circlip) for CV joints. Fitted to the front drive shafts, it secures the inner and outer constant velocity (CV) joints, retaining the joint on the shaft to prevent axial movement during operation.
€2.79
New3 in stockincl. VAT
1357627 is an exhaust manifold stud supplied in M8 x 17 and M8 x 19 lengths. Fitted to the exhaust manifold on vehicles equipped with 2.7 TDV6, 3.0 TDV6, 3.0 SDV6 and 3.6 TDV8 engines, these studs provide the fastening points required to secure the manifold to the engine.
€2.99
New6 in stockincl. VAT
LR001381 is an alloy wheel nut used to secure an alloy wheel to the wheel hub on compatible Land Rover models. Fitted to the wheel studs, this nut clamps the wheel to the hub and must be in good condition to maintain correct wheel retention and wheel bearing preload.
€3.95
New5 in stockincl. VAT
ERR2944 is a cylinder head fixing bolt specified as 7/16 UNC x 3.78. Fitted to the Rover V8 cylinder head, this bolt secures the head to the engine block on 3.5L, 3.9L and 4.0L V8 variants and should be installed following the manufacturer's head-bolt torque sequence and specifications.
€5.65
New3 in stockincl. VAT
K3dparts Pro Locator
