Land Rover is well represented in our warehouse. Check compatibility on each product page before ordering.
RRY500180 is an oil seal retainer for the swivel housing. Fitted to the front axle swivel housing, it secures the driveshaft oil seal and helps prevent lubricant escaping from the swivel assembly. This part is used on Land Rover Defender models 2007-2016 (from VIN 7A000001) on the front drive shafts.
€4.89
NewLast oneincl. VAT
is an exhaust gasket used to seal flanged joints in the exhaust system. It is fitted to 2.7 TDV6, 3.0D V6, 2.0 TIVCT, 2.2D and 4.4D engines on the Land Rover and Range Rover models listed below, preventing leaks where manifolds and exhaust pipes join.
€9.90
NewLast oneincl. VAT
CXE500040 is a Lock Cap Gasket - Handle. Fitted to the lock cap of the front and rear side door handles, the gasket creates a sealed interface between the lock cover and the door panel.
€18.55
NewLast oneincl. VAT
LR105592 is a Thermostat Seal fitted to the thermostat housing within the engine cooling system.
€8.33
NewLast oneincl. VAT
LR044836 is a 6mm Voss connector for air suspension lines. It is fitted on the compressor feed and on the top of the air spring on some models, providing a secure push-fit connection between sections of flexible air tubing and the suspension valve assembly.
€22.49
NewLast oneincl. VAT
LR027524 is a roof trim clip used to retain roof trim panels on Range Rover Evoque models. Fitted as part of the roof trim mounting system, the clip secures the trim panels in position.
€8.99
New11 in stockincl. VAT
LR023141 is a Thermostat Gasket. Fitted to the thermostat housing within the engine cooling system on 4.4L DOHC V8 Diesel Range Rover models, it seals the joint between the thermostat and housing.
€3.55
NewLast oneincl. VAT
CYC000010 is a Windscreen Cowl Centre Clip. Fitted centrally on the windscreen cowl panel, it secures the cowl to the vehicle bodywork and ensures correct alignment at the centre mounting point.
€1.99
New20 in stockincl. VAT
4 pin normally open relay with part number YWB101300. This relay has multiple uses. Multiple uses Include the heated screen, glow plugs, ABS and air suspension.
€19.46
NewLast oneincl. VAT
STC1739 is an injector pipe clip used to secure the rigid high-pressure injector supply pipes fitted to 300Tdi engines. This clip holds the supply pipes in place to maintain correct routing and secure attachment to the injectors.
€9.85
New2 in stockincl. VAT
TOF100040 is a 15.1mm hub spacer. Fitted within the front or rear hub assembly, this spacer locates the wheel bearing in the correct position and is identified by a green colour code.
€28.90
NewLast oneincl. VAT
DYX000010 is an O-ring fitted to the windscreen washer bottle and filler neck to seal the washer fluid reservoir. This seal maintains a watertight connection to prevent washer fluid leaks and to protect the system from contamination; inspect and replace if the O-ring shows signs of hardening, cracking or deformation.
€5.99
NewLast oneincl. VAT
K3dparts Pro Locator
