Land Rover is well represented in our warehouse. Check compatibility on each product page before ordering.
12H220L is a diesel injector seat washer. Fitted between the diesel injector and the cylinder head, it is used on 2.5 naturally aspirated diesel and 2.5 Diesel Turbo (19J) engines installed in Defender 90 and Defender 110 models.
€1.90
New6 in stockincl. VAT
LR011063 is a pin fitted to the timing gear auxiliary drive on 5.0 V8 AJ133 engines. It is supplied as part LR011063 and is used where specified in the timing gear auxiliary drive assembly.
€2.99
New3 in stockincl. VAT
LR073687 is a turbocharger O-ring, 14.3 x 2.4 mm. Fitted to the turbocharger lubrication and cooling passages on 2.0 L Ingenium diesel turbochargers, it seals oil connections to prevent leaks and ensure correct lubrication of the turbocharger.
€24.99
NewLast oneincl. VAT
Cylinder Block Plug.
€3.99
New3 in stockincl. VAT
LR033197 is an M14 flanged nut used to secure engine mounting assemblies on Range Rover, Range Rover Sport and Discovery 5 models. It is specified for use on the engine mounting fittings listed below; inspect the threads and replace the nut if damaged or corroded before refitting.
€2.89
New5 in stockincl. VAT
500447 is a Rubber Bush - Fuel Tank. Fitted as the rubber mounting that secures the fuel tank to its mounting brackets, it provides a resilient interface that helps isolate vibration between the fuel tank and the vehicle body/chassis.
€2.55
New4 in stockincl. VAT
DMJ500020 is a Water Reservoir Grommet. Fitted to the vehicle water reservoir, this grommet seals and protects the reservoir opening to help prevent leaks and keep contaminants out of the reservoir.
€4.99
New4 in stockincl. VAT
LR082314 is an EGR Manifold Gasket. Fitted to the exhaust gas recirculation (EGR) manifold on 2.0 L Ingenium diesel engines, it seals the mating faces to prevent exhaust gas and soot leaks and help maintain correct EGR system performance. When replacing this gasket, ensure the mating surfaces are clean and correctly aligned to achieve a gas-tight seal.
€10.99
NewLast oneincl. VAT
LR002658 is a sealing O-ring fitted to the air conditioning condenser and compressor assemblies on the models listed below. It provides the sealing interface at the A/C pipe and component connections to help maintain a refrigerant-tight joint and prevent leaks; any evidence of damage, hardening or oil staining indicates the O-ring should be replaced during A/C component service.
€2.35
NewLast oneincl. VAT
LR043932 is a rivet used to fasten sheet-metal components in bodyshell, floor pan and roof assemblies.
€2.10
New10 in stockincl. VAT
LR073734 is an EGR cooler gasket that seals the joint between the EGR cooler and the EGR valve on 2.0 L Ingenium diesel engines. This part is specified for the low-pressure EGR systems fitted to the compatible Range Rover Evoque and Discovery Sport models listed below.
€7.99
NewLast oneincl. VAT
FC112146 is an M12 flange head bolt, 12 x 70mm. Fitted to the front knuckle and hub assembly on Discovery 3 (L319) models, this flange bolt secures the knuckle and hub components together. Inspect the fastener for thread damage or corrosion during service and replace if any defect is found; install to the manufacturer's recommended fastening specification.
€5.19
New5 in stockincl. VAT
K3dparts Pro Locator
