Land Rover is well represented in our warehouse. Check compatibility on each product page before ordering.
Flange-head bolt. Fitted to the front knuckle and hub assembly, this bolt fastens components and the integral flange head helps to distribute the clamping load, reducing localised stress on the joint
€6.36
New3 in stockincl. VAT
This plastic component is used to attach headlamps to the body and, on some vehicles, to secure the fuel filler flap.
€10.18
NewLast oneincl. VAT
€7.42
NewLast oneincl. VAT
Rivet used to secure body and chassis trim components on applicable Land Rover models. It is fitted as a factory fastening for trim and chassis locations; inspect the rivet when panels are removed and replace any that are damaged or deformed to ensure a secure refit.
€8.48
NewLast oneincl. VAT
€7.42
NewLast oneincl. VAT
1/4-Turn Female Retainer Clip
€9.54
NewLast oneincl. VAT
Hex-headed bolt used to fasten components on front axle cases, transmission mountings and rear cross members across multiple Land Rover models. It provides the clamping required to secure these structural and drivetrain assemblies; when fitting, ensure mating faces and threads are clean and the correct fastener specification and torque from the vehicle repair manual are used. Inspect the bolt for corrosion, thread damage or distortion and replace if any defects are found.
€8.48
NewLast oneincl. VAT
Fuel pressure regulator O-ring fitted to the fuel pressure regulator on 2.0 TD4 and 3.0 TD6 engines. It is the specified Land Rover part for the fuel regulator seal used on Freelander 1 and Range Rover L322 applications.
€9.54
NewLast oneincl. VAT
O-ring for air conditioning compressor ports. Fitted to the air conditioning compressor ports to provide a seal at the compressor connections; inspect the O-ring for hardening, nicks or deformation whenever the system is opened or during air conditioning servicing.
€10.60
NewLast oneincl. VAT
Throttle body to inlet manifold gasket for 4.4D V8 engines. Fitted between the throttle body and the inlet manifold on 4.4L DOHC DITC V8 diesel engines, this gasket seals the joint to prevent intake air leaks that can affect running quality and trigger diagnostic fault codes.
€10.60
NewLast oneincl. VAT
M6 blind nutsert used to fasten exhaust heatshields and mudflaps on compatible Land Rover models. Fitted into thin panels where a permanent threaded hole is not available, this blind nutsert provides a captive M6 thread for secure attachment of heatshield and mudflap fixings.
€9.54
NewLast oneincl. VAT
€7.42
NewLast oneincl. VAT
K3dparts Pro Locator
