63 Suspension & Steering parts for Jaguar from our Hungary workshop — OEM and checked used components. Ships within the EU with no customs.
Nut used in the rear suspension. Fitted within rear springs and shock absorber assemblies, it secures the spring plates and associated fastenings. The nut should be checked for corrosion, thread damage or looseness during any suspension service and replaced if found damaged to maintain secure fastening.
€9.60
NewLast oneincl. VAT
M12 x 100mm flanged-head bolt used to fasten the front radius arm to the axle. It fits through radius arm bush ANR3332 and is secured with matching nut ANR1000.
€7.48
NewLast oneincl. VAT
M14 x 120mm used to secure front and rear suspension components. Fitted to suspension arms and strut assemblies, this bolt provides the clamping force required to retain suspension geometry; have installation completed and tightened to the manufacturer's torque specification and checked during suspension servicing.
€9.48
NewLast oneincl. VAT
LR096556 is a bolt used to fasten components within the rear cross member and stabilizer bar assemblies, the rear knuckle and suspension arms, and the front knuckle and hub assemblies. It is specified for use across the vehicle locations listed in the compatibility section and should be replaced if damaged or corroded to maintain correct suspension and hub integrity.
€9.72
NewLast oneincl. VAT
RUE000010 is a 51mm circlip. It locates and retains the wheel bearing within the hub knuckle, preventing axial movement on specified front and rear axle applications - confirm the correct axle and VIN before ordering.
€12.72
NewLast oneincl. VAT
255467 is a flanged-head bolt for the swivel pin housing. Fitted to the swivel pin housing, this bolt provides the securing fastener that holds the swivel pin housing in place.
€12.72
NewLast oneincl. VAT
LR002615 is an M18 x 1.5 tie rod adjusting nut. Fitted to the inner tie rod, this nut is used to adjust and then secure the track rod end so the steering toe alignment can be set and locked after adjustment.
€10.60
NewLast oneincl. VAT
Nut for Rear Knuckle And Hub, Rear Suspension Arms.
€12.72
NewLast oneincl. VAT
FRC8700 is a wheel hub locknut (early type) used on beam axle hubs. On early hubs two of these locknuts are fitted either side of a tab-type lock washer to clamp the hub nut and retain the hub assembly. Please note: on later hub designs (from approx 1998) the locking tab is integrated into the nut and RFD100000 is used instead.
€8.72
NewLast oneincl. VAT
LR024507 is a flanged hex-headed bolt M12 x 80mm. It secures knuckle and hub components on the front and rear assemblies, fastening the knuckle and hub hardware.
€8.60
NewLast oneincl. VAT
KYG000043 is a flanged head bolt, size M14 x 103mm, used to secure the front lower suspension arm on Range Rover L322 models. Fitted at the lower suspension arm mounting, the flanged head gives a larger bearing surface at the joint to retain the arm to the vehicle structure.
€9.00
NewLast oneincl. VAT
Nut for Steering Rack And Pinion.
€10.72
NewLast oneincl. VAT
K3dparts Pro Locator
